|
發現N1盒子網口速率僅為100Mpbs,后經測試發現可以關閉自動協商,手動強制開啟千兆,今天就來跟大家講一下解決N1網口速率百兆的教程。
N1盒子CoreELEC網口百兆解決辦法
在ssh后臺輸入如下代碼
- ethtool -s eth0 speed 1000 duplex full autoneg off
復制代碼 大約20s左右,執行完畢
- CoreELEC:~ # ethtool eth0
- Settings for eth0:
- Supported ports: [ TP MII ]
- Supported link modes: 10baseT/Half 10baseT/Full
- 100baseT/Half 100baseT/Full
- 1000baseT/Half 1000baseT/Full
- Supported pause frame use: Symmetric Receive-only
- Supports auto-negotiation: Yes
- Supported FEC modes: Not reported
- Advertised link modes: 1000baseT/Full
- Advertised pause frame use: Symmetric Receive-only
- Advertised auto-negotiation: No
- Advertised FEC modes: Not reported
- Speed: 1000Mb/s
- Duplex: Full
- Port: MII
- PHYAD: 0
- Transceiver: external
- Auto-negotiation: off
- Supports Wake-on: ug
- Wake-on: d
- Current message level: 0x0000003d (61)
- drv link timer ifdown ifup
- Link detected: yes
復制代碼 此時可以看到 Speed 為 1000Mb/s,全雙工。其他感覺播放可能受到網絡影響的可以試試這個(當然ethtool 查詢下來如果直接是1000Mb/s,可以忽略)。受限于IO,全千兆狀態下,下載速度大約25MBytes/s(200Mbps左右),超過80GB的原盤播放也應該沒有問題了。
分享網友:Fotix
以上就是跟大家分享的N1盒子CoreELEC解決百兆網速的方法啦,如果想要了解更多斐訊盒子玩機資訊,歡迎下載ZNDS智能電視網APP(下載地址:http://m.81jnr2m.cn/downapp.html)
|
上一篇: 請問刷了潛龍定制固件的貼友,內置的超級直播是哪個版...下一篇: N1刷完YYF固件插上硬盤不識別怎么辦?
|