移動魔百盒cm1101s8233 nand內存無法輸入命令求幫助

lcelebrate · 發表于 2017-12-3 17:13

連接ttl后顯示這些無法輸入命令
System startup
DDRS
Reg Version:  v1.1.0
Reg Time:    2016/1/18  14:01:14
Reg Name:    hi3798mdmo1g_hi3798mv100_ddr3_1gbyte_16bitx2_4layers_nand.reg
Relocate Boot to DDR
Jump to DDR

Fastboot 3.3.0 (rongxinjing@server180) (Aug 09 2017 - 15:08:37)
Fastboot:    Version 3.3.0
Build Date: Aug  9 2017, 15:09:42
CPU:          Hi3798Mv100
Boot Media: NAND
DDR Size:    1GB
Check nand flash controller v610. found
Nand CONFIG_NAND_NOTICE_RR is defined
Special NAND id table Version 1.36
Nand ID: 0x2C 0x64 0x44 0x4B 0xA9 0x00 0x00 0x00
Nand: Micron MT29F64G08CBABA Randomizer Read-Retry
Nand(HW-Auto): Block:2MB Page:8KB OOB:744B ECC:40bit/1k Chip:8GB*1
MMC/SD controller initialization.
No MMC/SD card detect when read `SDIO_CARD_DETECT` pin.
product_init,385: Get ID_WORD lock flag : 0

SDK Version: HiSTBAndroidV600R001C00SPC065_v2016112822
sw_mlcverify_init,28 start
mlcverify_offset:0x6200000
mlcverify_info_size:2584
[sw_mlcverify_check,95] start...
checksum:667, pmlcverify_info->checksum:667
[sw_mlcverify_check,114] ok,checksum:0x667
[sw_mlcverify_init,58] data at 0x006200000 is ok
maigic:MLCVERIFY!, count:10, time:1502704439
partition0: recovery(abd800) verify_value:c7fc
partition1: recovery2(abd800) verify_value:c7fc
partition2: baseparam(1350) verify_value:253b
partition3: baseparam2(1350) verify_value:253b
partition4: logo(30000) verify_value:db3a
partition5: logo2(30000) verify_value:db3a
partition6: fastplay(0) verify_value:0
partition7: fastplay2(0) verify_value:0
partition8: boot(864000) verify_value:3451
partition9: boot2(864000) verify_value:3451
[sw_mlcverify_init,88] ok
find logo in mlcverify
verify logo OK
find baseparam in mlcverify
verify baseparam OK
find boot in mlcverify
verify boot OK
SDK Version: HiSTBAndroidV600R001C00SPC065_v2016112822

Reserve Memory
Start Addr:       0xFFFE000
Bound Addr:       0x8D4E000
Free  Addr:       0xEC78000
Alloc Block:  Addr       Size
               0xFBFD000    4194304
               0xF8FC000    3145728
               0xF8F9000    8192
               0xF8C4000    212992
               0xF7C3000    1048576
               0xF7BF000    12288
               0xF43A000    3686400
               0xF2A4000    1658880
               0xEF1F000    3686400
               0xEC7B000    2764800
               0xEC78000    8192
[abortboot,108] begin
[abortboot,113] open loader keyed
Press Ctrl+C to stop autoboot
kernel  @ 3e08000 (8076440 bytes)
ramdisk @ 4e00000 (716810 bytes)
page size @ 2048 bytes
initrd rd_start = 4e00000,rd_end = 4eaf00a
## Booting kernel from Legacy Image at 020007c0 ...
Image Name: Linux-3.10.0_s40
Image Type: ARM Linux Kernel Image (uncompressed)
Data Size: 8076376 Bytes = 7.7 MiB
Load Address: 02000000
Entry Point:  02000000
XIP Kernel Image ... OK
OK
Starting kernel ...
[ 3.237774] libphy: PHY himii:1f not found
[ 3.487455] >>>  init /autoci02/home/projects/ANDROID-Hi3798M-SPC060-EMMC-kk-4.4/device/hisilicon/bigfish/sdk/source/kernel/linux-3.10.y/drivers/usb/usbir/usb-ir.c  usb_usbir_init
[ 6.028043] init: /init.rc: 196: invalid command '//on'
[ 6.033369] init: /init.rc: 252: invalid command '//chown'
[ 6.038869] init: /init.rc: 253: invalid command '//chmod'
[ 6.045862] init: /init.bigfish.rc: 80: invalid option 'sdcard_r'
[ 6.195263] init: /dev/hw_random not found
[ 6.199767] init: cannot open '/initlogo.rle'
[ 9.154570] init: /dev/hw_random not found
[ 9.213713] init: type = 0x5
[ 9.216709] init: reg_value = 0x5
[ 9.260186] init: [sw_properties_init,743] name: serialno, value: 003201FF0001182001AA60313BCD8B45
[ 9.269254] init: [sw_properties_init,743] name: standard, value: 1080i_50Hz
[ 9.276371] init: [sw_properties_init,743] name: secureline, value: 100
[ 9.283049] init: [sw_properties_init,743] name: stbid, value: 0
[ 9.289116] init: [sw_properties_init,743] name: cmcc_sn, value: 111001498394227
[ 9.302023] healthd: No charger supplies found
[ 9.313524] init: cannot find '/system/bin/rild', disabling 'ril-daemon'
[ 9.339870] init: cannot find '/system/bin/dbus-daemon', disabling 'dbus'
[ 9.376838] init: cannot find '/system/bin/teecd', disabling 'teecd'
[ 9.397837] init: cannot find '/system/bin/mtkbt', disabling 'blueangel'
[ 9.418866] init: cannot find '/system/bin/dtvserver', disabling 'dtvserver'
[ 9.428676] init: cannot find '/system/bin/gpio-led', disabling 'gpio-led'
[ 9.448054] init: cannot find '/system/bin/usb-driver', disabling 'usb-driver'
[ 9.473226] init: property 'sys.powerctl' doesn't exist while expanding '${sys.powerctl}'
[ 9.482814] init: powerctl: cannot expand '${sys.powerctl}'
[ 9.488879] init: property 'sys.sysctl.extra_free_kbytes' doesn't exist while expanding '${sys.sysctl.extra_free_kbytes}'
[ 9.501354] init: cannot expand '${sys.sysctl.extra_free_kbytes}' while writing to '/proc/sys/vm/extra_free_kbytes'
root@Hi3798MV100:/ # [ 22.654237] init: sys_prop: permission denied uid:1014  name:net.default.status
[ 22.664406] init: sys_prop: permission denied uid:1014  name:net.default.auth
[ 25.618347] init: sys_prop: permission denied uid:1014  name:net.default.status
[ 25.626182] init: sys_prop: permission denied uid:1014  name:net.default.auth
[ 58.956677] init: untracked pid 3655 exited

橙橙橙子丶 · 發表于 2017-12-3 19:16

幫頂一波

彼此的羈絆 · 發表于 2017-12-4 10:15

NAND的目前暫時無解

› 你問我答 / 玩機教程 / 固件 › ZNDS刷機/救磚